On the other hand, I couldn't always get RailDriver to work with Rail Sim locomotives some work, some don't. When the Pneumatic Control Switch (or PCS) is open, the train brakes cannot be released, and the throttle controls are deactivated. My understanding of RailDriver's speed display is that it was based on the screen speed display, first in Microsoft's Train Sim then (with quite a lot of effort) adapted to Rail Sim. My mapping (buttons 1-14 top row, buttons 15-28 bottom row): Arrow up reduces throttle (or increases DB).
9 7il TOM TOM CLUB ft 54 2 D TRAIN lom lorn Club, Sim SRK 3628 D train. The Last circuit was added on Saturday, August 21, 2021.Please note some adblockers will suppress the schematics as well as the advertisement so please disable if the schematic list is empty. Hudson was impressed with Poly- Gram's use of the 12-inch formal to break. To control DPUs, press the blue button 27 to put up the fence (26 for fence down), then control the throttle with the 2-way blue rocker switch: arrow down increases Throttle or reduces DB. If you wish, you can also turn off all elements of the HUD using the F1 key or you can hide just the element shown below using Ctrl + 5 keyboard shortcut. There are 2778 circuit schematics available. Repeat for the other controls, abd press the "Save" button at the bottom of the calibration window.ĮS44DCs have separate front and rear headlight switches, so on RailDriver the "Wiper (non-functional)" or top switch is for the front headlight, and the bottom or "Lights" switch for the rear. For the train brake, it seems to work best to set the "release" position very slightly above the bottom end of the handle's lower stop. Idle is set in the detent in the middle of the throttle, then press the window's Idle button to select the value.
#Run 8 train simulator key commands for breaker switch full
For example, for the Throttle, place it in the Full Throttle position and hit the window button for "Full Throttle" or Notch 8. For each button in the window, put the RailDriver control in that position, then press the window button. Just use Shift-F2 to open the Calibration Window (in Windowed mode, not Full Screen). If there are default key assignments, I've forgotten what they were.